HomeMy WebLinkAbout22495-ZFORM NO.3
TOWN OF $OUTHOLD
BUILDING DEPARTMENT
TOWN HAU.
SOUTHOLD, N.Y.
BUILDING PERMIT
(THIS PERMIT MUST BE KEPT ON THE PREMISES UNTIL FULL
,/'"'X COMPLE11ON OF THE WORK AUTHORIZED)
Y~
~te .~ ....... ~ .....................
N? 22495 Z
....................................................... ~ ............. ~ ........... ~,../. .......................................
CounIyTax Map No. 1000 Section ....... ~..~.. ...... Block ........ .~. ............... LotNo..C:~.L.~.. ..........
pursuant to application dated ............... ~....?..~ .......... 19.....~...Y, and approved bylhe
Building Inspector,
Fee $...~....~........~......
Rev. 6/30/80
LgTZOH PER N.
STATE
CODE
L
FI;~AL
~,DDITIOH/~L CO!4..(iEIITS:
Lumber
, POS #50257
· *Revised Edition
10' Wood Truss Barns
MINIBARN ASSEMBLY AND INSTALLATION INSTRUCTIONS
1. Cut and square 2 pressure treated bottom See illustration F for cutting details.
ribbon boards to 12'0" or 16-0".
2. Cut and square 2 top ribbon boards to 12'-0"
or 16-'0"
3. Nail the bottom ribbon board to one standard
fr,=me using 16d n~ils. See tllustratk~r,
4. Nail the bottom ribbon boards to the balance of
the standard frames.
5. Nail the top ribbon boards, to the standard
frames as shown on..lllustratlon A.
8. Gut and nail in place 5/8" floor sheathing, using
8d nails, as shown on Illustration B. (Deluxe
Package Only)
7. Cut side wall sheathing and nail in place using
8d siding nails. See illustration C for cuffing
details.
8. Cut and square front and rear end wall framing.
Toe nail In place using 16d nails. See Illustrations
D and E for details.
9. Cut and Install roof sheathing using 8d nails.
10. Cut front and rear wall sheathing and nail in
place using 8d siding nails. See illustrations G
and H for cutting Instructions.
11. Assemble the door panels. Screw through the
Lack side of the door panel Intr) the lx
uaing the l-iA" screws provider'~ See iliusiratloh
I for Instructions.
12. Cut and nail waferboard soffit in place using
8d siding nails.
13. Apply lx4 trim to corners and rake using 8d
siding nails.
14. Apply lx4 trim around door opening using 8d
siding nails.
15. Install roofing as per manufacturers instruc-
tions using 1-1/4" roof nails. (Deluxe
Package Only)
16. Install door panels using hinges, hasps, barrel
bolts and screws provided.
17. Paint and/or stain barn as desired.